SparkFun Breadboard Power Supply Stick – 3.3V/1.8V

  1. Home
  2. Your robotics shop!
  3. Prototyping
  4. General
  5. SparkFun Breadboard Power Supply Stick – 3.3V/1.8V

SparkFun Breadboard Power Supply Stick – 3.3V/1.8V


SparkFun Breadboard Power Supply Stick – 3.3V/1.8V

13 in stock

SKU: PRT-13157 Categories: , Tag:


This is a very simple board that takes a 4-9V input voltage and outputs a selectable 1.8V or 3.3V regulated voltage. All headers are 0.1″ pitch for simple insertion into a breadboard.

Input power can be supplied to either the DC barrel jack or the two pin header labeled + and -. Output power is supplied to the pins labeled GND and VCC. Board has both an On/Off switch and a voltage select switch (3.3V/1.8V).

The two sets of four GND and VCC pins are spaced such that when connected to our Basic Breadboard both power busses will be powered.

Note: Headers are not supplied. You will need to supply your own headers to connect this board to a breadboard. Check below for some breakaway header strips.

Dimensions: 2.15×0.65″


  • 4-9V input voltage via barrel jack or 2-pin header
  • 3.3V or 1.8V regulated output voltage
  • 800mA Operating Current
  • ON/OFF switch
  • Output voltage select switch
  • Power status LED
  • PTC fuse protected power
  • 5.5×2.1mm center positive barrel jack


Additional information

Weight 0.0145 g
Dimensions 56 × 17 × 15 mm


There are no reviews yet.

Be the first to review “SparkFun Breadboard Power Supply Stick – 3.3V/1.8V”

Your email address will not be published. Required fields are marked *

3 × 3 =